One Design Parts

Stainless steel bailer springs for the ILCA autobailer. A durable replacement for the rubber o-rings. Improved design for smooth opening and closure of the bailer chute.

The Optimist daggerboard bungy from Optiparts is made of 6 mm dinghy shockcord with red pvc handle to retain the Optimist daggerboard in it’s case. The legal handle to keep your Optimist daggerboard in place and your Optimist hiking strap up too...

New colored trimstrip from Optimax Spars so you can fine tune your Optimist trim. 

Replacement Opti wind indicator vane in BLUE. Fits the standard 5 mm shaft found on the Opti Low Friction Wind Indicator from Optiparts. *Vane only*

This 16mm Single beckett block is one of the smallest blocks made by harken. On the RS Aero, it is part of the vang system.

Selden medium sized failead eyelet used on selden mast products   Selden Part Number: 508-604

Opti mainsheet made from the Rooster Polilite 6mm revolutionary non-twist mainsheet. With the load bearing outer cover gripping the lightweight inner core, the risk of being confronted by a tangled mainsheet on a crucial bear away is greatly reduced...

These bailer spring plates are manufactured using the highest quality spring stainless steel, designed to both retract using spring tension, and at the same time providing a surface for the activator to push against to close the chute.

The ultimate clew tie down for the ILCA.The strap holds the clew tightly in place using velcro and through clever design it is easy fitted and yet still slips nicely along the boom.Also suitable for use on the RS Feva.