This is the complete ILCA auto bailer, ready to install. Mounts to all model year boats. A pull on the cockpit drain plug opens the chute ont he bottom of the boat and allows water to drain from the cockpit. Kit includes the full bailer assembly and installation hardware.
A bailer repair kit is also available elsewhere on this site.
LP Part # 91009
Works as intended, easy to install. Use a dab of silicone or 4200 on screw hole. Tyvek tape over front of bailer, easily replaced, keeps the front edge of the bailer down. Buy the rooster spring, or spare rings for annual replacement.
This is a Nautos bailer. Easy installation. The O-rings typically last 1 season. The rubber O-rings pull the water trap back into position and stretch when it is open. They deteriorate with use and salt water. If you can find replacement springs they last longer. It’s not a bad idea to seal the edges with a small bead of sealant (NOT 5200). If the boat is stored upside down in the sun, it looks like the leading edge can curl in the sun then get caught on dolly straps or docks when pulling the boat out.