ILCA Parts

The standard boom block is mounted to the mid point of the ILCA boom. Pass your mainsheet up from your mainsheet block, through the boom block, and then aft to the boom block with becket to complete your rigging. Attaches to the boom with the stainless...

The boom block with becket is attached to the aft end of the ILCA boom. Pass your mainsheet through the block, down to the traveler block, and back up to secure to the becket. A great upgrade for an older boat, particularly for light air sailing!...

The ILCA Vang Upper Block is a Harken wire block with becket with attached vang key. It features indented sides to prevent the line from slipping off the sheave. The included vang key is the latest 'updated' style with larger head for improved strength...

Upgrade your ILCA vang with this new high load upper vang block from the hardware experts at Ronstan. Introduced as part of the Series 30 Block collection, the RF34108HLK is a low friction, low profile vang block with clevis pin for removing vang key...

The 16 mm is Harken’s® smallest block. It is perfect for small synthetic control lines found on high-tech dinghies. The patented bearing system uses stainless steel balls in a captive grooved race. Sheave 16 mm / 5/8 in Length: 54 mm / 2 1/8...

Nylon wear protection pads for the ILCA dinghy. Designed to stop the mainsheet blocks from damaging the deck of the boat. The wear protectors clip around the traveler fairlead and are held in place by friction and the traveler rope. There is no overhang...

Replacement deck mount bracket for the Nautalytics Laser/ILCA compass. Includes an anodized aluminum deck bracket with two (2) sets of 3M™ Dual Lock adhesive and four (4) mounting screws Made by Nautalytics Lightweight anodized aluminum...

The ILCA Daggerboard Friction Pad MK2 is screwed to the back of your Daggerboard casing and allows for perfect grip and slip ratio when raising the board. The New and Improved design lets you replace the Rubber Pad housed inside the Plastic Casing...

This product gives you all you need to get your ILCA toe strap adjustable on the CL828-68AN cleat

This pre-cut section of 6mm gray Dynema is made for an ILCA traveler. It is 144 inches long and has a 2 inch splice in one end. 

This hiking strap from Zhik is designed to go with Zhik's "Zhikgrip" boots. The underside of the hiking strap and the top of the boots have rubber studs designed to "lock" together when hiking and allow the sailor to hike for longer and be more...

Block Plate, w Blocks, Harken for the ILCA Sailboat.